Since my current IPFire firewall is running on a legacy 586 type hardware PC Engines APU1D, I am trying to migrate my firewall setup to a new 64-bit PC Engines APU4D4 hardware. My plan is to clone my current firewall to the new system and then just exchange them with minimum interruption.
I was able to restore the backups from my current APU1D based IPFire firewall on my new APU4D4 hardware. All configurations including passwords were preserved
Then I followed the migration recipes from hardware-change.
So far, everything worked as expected. I can log into the admin Web User interface.
However, I need your help to re-configure the 4 network ports of the APU4D4 (the APU1D had only 3 network ports). My target network configuration is as follows:
1st Ethernet port: red interface
2nd Ethernet port: orange interface
3rd Ethernet port: green interface e.g. 192.168.1.1/24
4th Ethernet port: green interface e.g. 192.168.4.1/24
hostapd: blue interface e.g. 192.168.2.1/24
How can I set-up the different address ranges of the two green interface ports in set-up?
The setup of the network interfaces allows me to define only one address range for the green interface, e.g. 192.168.1.1/24
Is it possible at all to define different address ranges for the two green ports?
If this is not possible, how are then the IP addresses of the two green ports set?
Many thanks for your help in advance.