Wireguard N2N setup inside LAN

Virtual Private Networks WireGuard
1

Hello

I have the house owner network setup LAN is 10.100.102.0/24 .
In my private floor/apartment iv set up two different ipfire networks under that house LAN because i dont want to be in the same network with him .
one ipfire network is for my lab and the other one is for the rest of my apartment .

ipfire A (lab):
WAN - 10.100.102.17
LAN - 10.0.0.0/24

ipfire B (apartment)
WAN - 10.100.102.111
LAN - 192.168.1.0/24

Iv tried to setup an Wireguard NET2NET between those firewalls just for fun and learning, i don’t really need these encrypted tunnel between them, but i do want to accomplish that .

anyway i did setup but it doesnt work. my setup is correct ?
also im not sure which FW rules to create.
please help .

this is the initial peer setup:

ipfire A peer setup
ipfire A peer setup1036×644 58.4 KB

and there are the configurations :

site A conf
site A conf1007×677 43.4 KB

site B conf
site B conf999×668 46 KB

2

Hi John.

Key material should never be posted online, even if these are keys which are not going to be used in production.

I have edited your post.

Thanks,
A G

1 Like
3

Hi Adam.
Thanks for the clarification . iv edit the post a bit.

Can you tell me whats wrong with my configuration ? whats fw rules i should set ?

4

Did you select Enabled and then click Save?

obraz
obraz463×167 16.5 KB

5

apparently not. thank you its works now. i thought enabled checkbox is only for the host-to-site.

thanks

1 Like