Hello Team,
I saw that new IPFire version received patches for Traverse Ten64 device, I was able to install IPFire with aarch64 ISO file and was able to finished installation step.
After reboot, I saw bootlog then the serial output is full of non readable characters :
Moreover, I also tried the flash image and got some output and then same output as in the screen above.
Best regards,
Nikos
Looks like a problem with the com speed. IPFire use 115200 as default. (but if you have installed from iso it should set the same as in installer also in finished install)
If your bootloader use different speed you may run into problems.
Also keep in mind that the TEN64 support is not finished yet. There are some changes to the u-boot config that i have not checked yet because im working on an update to a newer u-boot first…
Ok I understand, regarding speed, I used info from Ten64 wiki.
If you need some testing, I can provide some help.
Regards,
Nikos
Hello Team,
I was able to complete installation of ipfire-2.27-core175. At the moment booting on my nvme disk does not work. I need to do some tests in order to understand what part is blocking.
Regards,
Nikos
