Hello All, I’m new to IPfire not some much with linux in general. I can install IPfire without issue but I am unable to access the webinterface. I’ve tried doing it directly through the ethernet to a PC and through my router and I get nothing. Is there a way to access directly through the PC IPfire…

[image] thelyon: Is there a way to access directly through the PC IPfire is installed on? This is intentionally blocked. You need to work through the steps in: web_interface which should be accessible via: https://{your IPFire green0 address}:444

To say it the other way. IPFire doesn’t have a Graphical User Interface, but a Web User Interface. The most direct interface to the OS is the console, implemented either as keyboard/monitor or serial connection ( depending on the HW ). Console access is also possible using SSH; but this needs bas…

Hi @thelyon If I understand you correctly you have installed IPFIre on a mchine and you have tried to access the WUI on a PC connected to the Green Ethernet interface. You say you “get nothing” but there must have been some sort of error message. It would be helpful to know what that message was. …

Yes I have tried the host name and IP address. All I get for an error message, if you can call it that, is a boiler plate can not connect page in my web browser. Both host name and IP get the same blank message. I’ve tested the ethernet ports and both work under using linux mint live usb so I don’…

[image] thelyon: Reinstall and try again?.. bad install maybe? You could do that but I think it is worth doing a bit more investigation first to see if we can find out what the problem is. Are you able to access other url’s such as ipfire.org or is all web access saying that it cannot connec…

[image] bonnietwin: Maybe someone else can suggest how to or give hints on what/where else to look at. On ipfire console, commands ip address or ifconfig will show the actual settings of all interfaces.

Hello, I am having a similar issue. I am not able to access the web interface, but I am also not able to connect any system to the “Green”/LAN. It appears to me that no systems on the Green side are being assigned an IP address. I have checked /var/ipfire/dhcpc/dhcpcd-red0.info mentioned above and …

Have you configured a valid IP Address and Netmask on green and also configured the DHCP Range inside this Network. You can reconfigure green IP and networkmask with “setup” and there is also a way to access the WebUi on the IPFire itself to reconfigure the DHCP but it is uncomfortable. Type “elink…

I believe I have configured a valid IP Address and Netmask on Green and also configured the DHCP range. Below are the details. Configuration type: Green + Red Green IP Address: 192.168.2.1 Green Netmask: 255.255.255.0 For DHCP Settings, I can only find those in regards to Red I have selected “D…

This are the wrong DHCP settings. (This is the client for the red side) I think you have just not enabled the DHCP Server in the Installation process. To access the WebUi you have to set a fixed IP in the same Network (192.168.2.2-192.168.2.254) to your client that is connected to the green nic. A…

IPFire Community

New Install Can't Access Web interface

Installing & Running IPFire

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled