IPsec connectivity issues

Having some issues with a basic Ipsec connection using a pre shared key with new version 158. In older versions setting up a simple connection using this method was straight forward. Create a net to net connection, chose a pre shared key and connect. Once connected I would have no problems seeing the entire range of Ip addresses on each side. With 158 following the same basic methods of setup one side can only connect to a few specific ip addresses the remote side seems fine.

Also having numerous issues with OpenVPN but will describe those in a separate post.


welcome to the IPFire community. :slight_smile:

Could you please describe your issue a bit more detailed? Which IP addresses are you able to connect? What do your IPsec configuration and the routing table look like?

Thanks, and best regards,
Peter Müller