How to configure Elinks on Serial to show a full view

[tphz (iptom)]

@smice-byte

The question to the forum is how to configure Serial to show a full view.

It may have something to do with the resolution.
I don’t use a serial console so I can’t check this.

Below is a link to a topic about changing resolution:

Increase monitor resolution

Hello, My monitors have a resolution of 800x600 which is not very practical and the syncronization (VGA) leaves a lot to be desired. A test under Ubuntu, on the same device, showed that the Graphig with higher resolution gave better results. Therefore, I would increase the resolution a bit. I have read on the net that is to be set in Grub. My question which one do we have 1/2? And where must what pure?

---

Below are examples of screenshots of the test VM for different resolutions:

640x480

800x600

1024x768

1280x1024