Doc question about firewall defaults

[dwin64 (Daniel Winsor)]

I have modified the firewall rules.
not sure I have it correct.
Is there a doc that shows screenshots of default firewall rules.
(Would be nice to have a “reset to defaults” button.)

Also, are there any screenshots showing the firewall rules to block 80,443 and have that traffic only go through the proxy?
(Again, a single checkbox for a commonly used feature like this would be great)

[hvacguy (Shaun HVAC)]

Hope this helps.

Firewall Default Policy - The IPFire Documentation

Best read ever.
https://www.ipfire.org/blog/firewall-configuration-recommendations-for-ipfire-users

[jon]

@dwin64

Is there a doc that shows screenshots of default firewall rules.
(Would be nice to have a “reset to defaults” button.)

If you started before CU 182 the default WebGUI Firewall Rules is blank (no rules).

As of Core Update 182 this is the WebGUI default. See:

Core Update 182 - where is port 25 blocked?

It is part of the Firewall Rules! And it can be easily disabled! [Screen Shot 2024-01-05 at 12.57.23 PM]

Does the help?

---

EDIT: See this wiki page:

Block outgoing SMTP - The IPFire Documentation

---

EDIT2:

@dwin64

Also, are there any screenshots showing the firewall rules to block 80

I do not use the convention proxy so I probably have this wrong… But you should be able to copy the above rule (blocks outgoing port 25) and change the port 25 to port 80. That seems like it should work.