Ath10k pdev param 0 not supported by firmware2.29 (x86_64) - Core-Update 183

Networking
1

IPFire Mini-appliance, IPFire 2.29 (x86_64) - Core-Update 183, hostapd-2_10-63

Wireless section of log is filled with “kernel: ath10k_pci 0000:05:00.0: pdev param 0 not supported by firmware”

and WiFi doesn’t work. How do I set the “pdev param”, and what values work?

2

I have not heard from this problem yet but OpenWRT forums are full of this error but not usefull. Sometimes wrong config, bad pcie slots …

So i can only ask same questions about your config
Is the country code configured? (Since a while new drivers/firmware doesn’t accept default “00” anymore)
Which channel and mode is used?
Are special flags configured?

1 Like