I was running an older version.
I ran update in pakfire and show no newer version after reaching 183.
Please advise
I was running an older version.
I ran update in pakfire and show no newer version after reaching 183.
Please advise
I suggest doing a fresh install
The major version up to CU182 was 2.27
IPFire 2.27 - Core Update 182
From CU183 to today the Major Verison is 2.29
Pakfire is not able to update in one go across major versions. So do the upgrade to the version that Pakfire shows you. When that update has completed and you have rebooted if you then go to Pakfire again and if required update the lists then you should see the update up to CU205 now being available.
Incidentally, if you were running earlier than CU183 then you were more than 30 months out of date with updates and having missed many fixes for many security vulnerabilities.
This is not the best approach for a firewall which is your boundary protection system between your home and the wild west of the internet.
yes I realize I’m way behind. It is a firewall behind another firewall.
pakfire shows no available updates. I do not see CU205
I am on 2.29 183
this is what I’m trying to avoid.
I’m also wondering if it’s not reaching the main update site. The mirror sites complete successfully but I get a error on the pakfire addresss
DOWNLOAD ERROR: 500 Can’t connect to pakfire.ipfire.org:443 (Name or service not known)
Additionally, after the update to this current version, my wifi AP thinks it can’t reach the internet but it is working.
I may just do a fresh install afterall.
If you pressed the Refresh List button and that has not made any updates show up, then I am not sure what is causing it.
Previously someone else had the same problem going across major versions and I tested it out and was able to successfully do the update in two steps.
However if it is not working for you, then your best bet is to follow the suggestion from @alexand of doing a fresh install of CU205 that was released today.
yep, just burned the CD
Thanks
all issues resolved
now on IPFire 2.29 (x86_64) - Core-Update 205
Yes, you must have corrupted your installation in some way to not be able to upgrade from 183 to 205.
I just installed CU170 on a vm system and it said that there was an update up to 183 available.
I the pressed the button to update it, which it did.
Then I rebooted. Then I went to the pakfire screen and the Available updates section was empty.
I then pressed the Refresh list button and it then showed me updates available up to CU205.
It is now going through those updates.
So it has worked as it did in the past for me, so if it failed to do that on your system then it must have become corrupted so that it would not properly update.
In that case a fresh install is the best thing and will have been faster as well than doing around 30 or more core updates in sequence.
Agreed, something must have gotten corrupted.
The wifi AP also no longer thinks it has a problem.
It has an red light to come on when the internet is down.
It was red, but the internet was reachable.
Now there’s no light which is normal.